Servo test unit (CCPM servo tester)

The block for testing servo drives is designed to test the performance of the servo drive and determine its extreme angles. Allows you to estimate the speed of movement and the minimum step. It can be very useful for RC modellers as it allows you to quickly get the drive up and running and test the model before the control electronics are ready. Up to 3 servos can be connected to the servo tester at the same time, such as SG90, SG92R, MG90S, MG995, MG996, EMAX ES08MA, etc.

It has three modes of operation: manual, neutral and automatic. In manual mode, the servo position is set by turning the variable resistor knob on the front panel. Neutral mode sets the servo to the middle position. In automatic mode, the servo constantly moves from one extreme position to another. Modes are selected by the "Select" button located in the lower left corner. The current mode is indicated by the corresponding LED above the control knob.

Specifications:

Output current: ≤ 15mA @5.0V
Input voltage: 4.8 - 6 Volts
Overall dimensions: 42 x 24 x 23 mm.