DC-DC boost converter 10...32V to 60...97V 100W (2A max.)

This module is a powerful and reliable DC voltage converter. The converter changes the DC output voltage in the range from 60 to 97 V. The module has a wide high voltage range, so it can be used to power high-power LED strips, matrices, powerful lighting, etc. Also, the voltage converter can be used in the design of various power supplies, chargers and other devices.

Adjustment of the DC output voltage is carried out using a multi-turn trimmer. Before connecting the module to the load, it is necessary to turn the regulator to the initial position, and then set the required output voltage. The maximum output power of the module with a heat sink installed is 70 W, and with additional cooling it is 100 W. The output current of the converter can reach up to 2 A. The efficiency of the module is about 85%. For safety reasons, the heatsink installed to the microcircuit case is isolated from it.

Connecting the converter to the screw terminals is quite simple. Terminal pin assignments:

IN+: input voltage 10-32V
IN-: "ground"
OUT+: output voltage 60 - 97 V
OUT-: common load wire
Power is supplied from an external power supply. The DC input voltage range of the converter is from 10 to 32 V, and the output voltage range is from 60 to 97 V. The red LED, which is connected to the power bus, indicates power supply to the module.

The module is not protected against short circuit (short circuit) and reverse polarity. If you need to install reverse polarity protection, you need to connect a diode or a diode bridge to the input terminals.

Input voltage, V 10 ... 32
Output voltage, V 60 ... 97
Maximum output power, W 70 (100 with additional cooling)
Efficiency, % 85
Maximum output current, A 2
No-load consumption current, mA 35
Voltage regulation, % 0.5
Load regulation, % 2.5
Operating temperature range, °C -40 ... +85
Module dimensions, mm 65 x 47 x 23.5.